From 9e1f971f760badd76ba753385cefdd4cdc076a43 Mon Sep 17 00:00:00 2001 From: Christian Pointner Date: Mon, 6 Jan 2020 14:42:52 +0100 Subject: fix some typos in manpages --- doc/anytun.8.txt | 6 +++--- 1 file changed, 3 insertions(+), 3 deletions(-) (limited to 'doc/anytun.8.txt') diff --git a/doc/anytun.8.txt b/doc/anytun.8.txt index 7896dcd..8c5a3b6 100644 --- a/doc/anytun.8.txt +++ b/doc/anytun.8.txt @@ -109,7 +109,7 @@ passed to the daemon: packets. In case of anycast tunnel endpoints, the anycast IP has to be used. In case of unicast endpoints, the address is usually derived correctly from the routing - table. The default is to not use a special inteface and just + table. The default is to not use a special interface and just bind on all interfaces. *-p, --port ''*:: @@ -145,7 +145,7 @@ passed to the daemon: of multiple anycast hosts. The unicast IP address of the anycast host can be used here. This is needed for communication with the other anycast hosts. The default is to - not use a special inteface and just bind on all interfaces. However + not use a special interface and just bind on all interfaces. However this is only the case if synchronisation is active see *--sync-port*. *-S, --sync-port ''*:: @@ -210,7 +210,7 @@ passed to the daemon: the multiplex id to use. default: 0 *-s, --sender-id ''*:: - Each anycast tunnel endpoint needs a uniqe sender id + Each anycast tunnel endpoint needs a unique sender id (1, 2, 3, ...). It is needed to distinguish the senders in case of replay attacks. This option can be ignored on unicast endpoints. default: 0 -- cgit v1.2.3